Eaton RF System 2.42, Руководство пользователя

Страница: 135 / 244

135 Eaton RF-System
© 2015 Eaton Electrical Group
: long press on the button, top
: long press on the button, bottom
: short press on the button, bottom
12-fold remote control:
The 12x remote control (sensor) can control all xComfort actuators (switching actuator, dimming
actuator, shutter actuator, etc.) and can also send a command to the Home Manager RF, Room
Manager, etc.
The remote control has 6 pre-selection buttons and 1 switch rocker and is equivalent in terms of
functional scope to 12 single buttons.
Each pre-selection button has 2 levels. There are 2 factors which determine which channel you are
in: the number of the pre-selection button and how often this is actuated. This leads to a total of 12
channels.
The yellow (left) and green (right) LED show which level you are in. If you actuate a pre-selection
button once, the yellow LED lights up briefly; if you actuate it twice, the green LED lights up briefly.
The switch rocker functions as a single button and should be regarded as 1 sensor channel.
A command is sent when the switch rocker is actuated. The LEDs on the left and right show when
a command is sent (flashes briefly once) and when the command has been acknowledged by the
destination device (or the next device in the event of routing) (flashes briefly twice). When the
command has been successfully sent and acknowledged, the LED then flashes three times. If this
all happens in a channel in level 1, the left LED is used for this process, whilst the right LED is
used for level 2.
Example:
Preselection operations Channel LED
1 1x 1 yellow
1 2x 7 green
2 1x 2 yellow
2 2x 8 green
3 1x 3 yellow
3 2x 9 green
4 1x 4 yellow
4 2x 10 green
5 1x 5 yellow
5 2x 11 green
6 1x 6 yellow
6 2x 12 green
Drawing a connection between the 12x remote control and an actuator causes a selection window
to open.
It is usually set up as follows: