Eaton RF System 2.42, Руководство пользователя

Страница: 82 / 244

82 Eaton RF-System - Help
© 2015 Eaton Electrical Group
Among them, depending on the functions that are set, several slider controls (control time,
runtime, interval time), which allow you set time-related functions.
Another item is setting the dimming time, which defines how long it takes a analog actuator to dim
from 0% to 100%. It can be selected individually for each command, but the maximum dimming
time is 250 seconds.
5. In this box (bottom right) you can set the dimming limits as well as the behaviour of the
transmitter in case of power recovery or low battery, if the relay should also switch and the desired
dimming characteristic curve..
The dimming limits define the range within which the actuator will dim (standard min. 20% to max.
100%).
In case the sensor battery is low, you can select whether or not the analog actuator should send a
warning after switching it on (output blinks once).
Regarding power recovery, you can pre-set how the dimming actuator should react to it. There are
three options to choose from:
Old value (Standard): Actuator maintains the same state as before the power
failure
On: After power recovery the actuator switches the output ON
Off: After power recovery the actuator switches the output OFF
The characteristic curve for dimming can be set linear or logarithmic.
6. Activate memory function: By setting this option, the analoge actuator remembers the last value
used before switching off and switches on again to precisely this value when it receives the next
ON command.
7. Dim to a percentage value: If this function is activated the analogue actuator will react on a
direct percentage value command (0-100%) by dimming to that value instead of immediately
jumping to that value. The set dimming time will be taken into consideration. The option will only be
available if the connected sensor is a Room-Manager, Home-Manager or communication
interface.
All functions of the analog actuator:
On / Off Dimming (Standard), occupies 4 command buttons
Switches ON presp. OFF
On / Switch-on Delay, occupies 1 command button
ON command that comes either immediately or after an adjustable delay time
Off / Switch-off Delay, occupies 1 command button
OFF command that comes either immediately or after an adjustable delay time
Off with preliminary Warning, occupies 1 command button
Stair case function which switches on immediately and turns off after an adjustable time.
Before
the analog actuator switches off, the output will blink once 15 seconds earlier as an
advance warning.
Dimming function, occupies 2 command buttons
The analog actuator switches ON after a short push at the push-button or key, and OFF
after a long push at the push-button or key, and it dims up or down after a long push at the
push-button or key.
Momentary contact mode, occupies 1 command button
The analog actuator changes its initial state by dimming each time it is activated.
Flashing mode, occupies 1 command button, takes the dimming time into account
After activating it, the dimming actuator starts blinking after an adjustable interval time
Desired Brightness, occupies 1 command button
The analog actuator dims to a pre-set brightness value, at the pre-set dimming speed
(dimming time)
No Function, occupies 1 command button
No function – as its name implies
Functions for Push-button, Hand-held Transmitter and Binary Input Bat/230 Mode 4:
On / Off / Dimming (Standard)
ON / OFF / Dim (Brighter) / Dim (Darker), only