Magnefix MD4
991.184 G01 03
41
7. Slide the cable box on to the cast resin insulation of
the panel.
8. Draw the cable beside the cable box until the
polyethylene tape protrudes about 10 mm below the
cable box.
9. Mark the cable with a line (M) immediately above the
cable clamp (A).
10. Remove the cable box from the cast resin insulation.
11. Insert the cable into the cable box from below and
lower the cable box on to the cable as far as possible.
7..10
12. Fix the cable in the cable clamp (c) at position (M)
previously marked. Move the distance piece (b) until
the centre of the cable is exactly in line with the centre
of the cable box. Firmly tighten the cable clamp.
12
13. Seal the openings of the cable box (b) to prevent
intrusion of dirt.
14. Cut the cable cores 2 to 3 mm below the cast resin
insulation (a).
15. Remove the paper insulation from the cable cores over
a distance of 30 mm.
16. Check that the O-rings (c) are fitted across the cast
resin insulation.
17. Apply cable grease lightly to the cast resin insulation.
13 .. 17
M