Magnefix MD4
48
991.184 G01 03
Procedure
1. Incise the cable at the correct length, as shown.
L1 = 650 mm
2. Terminate the cable, as shown.
L2 = 175 mm
d = diameter across the lead sheath
Remove the lead sheath over distance (d).
Remove the sharp edges of the lead sheath.
R
EMARK
To simplify insertion of the cable cores in the right
tubes of the cable box, it is recommended to cut
the cable cores to different lengths.
1, 2
3. Saw off the entry bushing in accordance with the
diameter (d) measured across the lead sheath. Take
into account that several layers of polyethylene tape
are to be applied over the lead sheath.
4. Deburr sharp edges.
3, 4
5. Degrease the upper side of the lead sheath and sand
it lightly, for example, with a scouring pad.
6. Apply a couple of layers of polyethylene tape to the
lead sheath, so that the diameter measured across the
tape equals the inside diameter of the entry bushing.
Ensure that the upper side of the tape is flush with
that of the lead sheath (see arrow).
Smooth out any wrinkles.
5, 6
