Dukane ES, Руководство пользователя

Страница: 72 / 180

Figure 5–32
Process Limits - No Display
Figure 5–34
Process Limits - Bad Limits
Figure 5–33
Process Limits - Display Only
Data from Process Characteristics
Data from each weld cycle can be monitored through the
available process characteristics.
Programming choices for each characteristic are:
— No Display,
— Display Only,
— Bad Limits, and
— Suspect Limits.
No Display
Figure 5-32 shows that Position is the selected process
characteristic, and no choices have been made for that
characteristic. Weld characteristic is not displayed.
Display Only
Figure 5-33 shows Display Only was chosen for the Weld
Time process characteristic.
That process characteristic is displayed during normal op-
eration on the Operate screen.
Bad Limits
This is also known as Bad Part Limits.
Figure 5-34 shows that Peak Power is the selected char-
acteristic. Bad Limits are ON , and Low Limits and High
Limits need to be set.
The Bad part limits are used to establish boundaries that de-
fine unacceptable results for parts that are being processed.
If a bad limit is either not met or is exceed, the weld cycle
is ended immediately, and the operator is notified in these
ways :
• Two beeps are given (if buzzer is set to ON ) .
(See Buzzer , Page 80.)
• The
iQ
ES bad part output is activated.
• BAD is displayed in the part cycle data.
Process Limits, Continued from Previous Page
Process Limits, Continued
Page 66
iQ Series Ultrasonic Generator/Power Supply, Servo Systems, ES User’s Manual
Dukane Manual Part No. 403-587-00