PRORXD Broadcast Receiver User Guide
Commercial in Confidence
Broadcast Solutions, HD/SD Products,
PRORXD
100167
Revision: 7.0
Commercial in Confidence
Page 8-86
8.
Appendix A – Cautions and Warnings
8.1
Cautions and Warnings
Serial
Area
Note
1
Enclosures
Do not remove factory installed screws or fastenings. Damage to the units
can be caused and void warranties.
Only approved personnel must open the device. There are no operations
that required the user to access the device internally. There are no user
serviceable parts internally.
2
Maintenance
Other than cleaning, no scheduled maintenance is required to make sure
of the correct operation of the unit.
3
Environment
The equipment must not be used in dangerous or atmospheres that can
cause corrosion. Users are reminded of the necessity of complying with
restrictions regarding the operation of radio devices in refuel depots,
chemical plants and locations where explosives are kept and/or used.
4
Power Supply
Make sure that the power supply arrangements are sufficient to align with
the requirements of each device. Obey all electrical safety precautions.
5
Electro Static
Discharge (ESD)
Precautions
ESD guidelines must be followed for this electrostatic sensitive device.
6
Lightning Hit
There is a risk of lightning hits to antennas. The equipment must not be
assembled in an area during lightning. Antennas must be adequately
protected from lightning hits.
7
Working at
Height
You must be careful when locating the device at height, for example on a
mast. Make sure the unit is correctly attached to stop it falling and
injuring personnel.
8
Risk of Eye Injury
You must be careful to stop your eye touching the antennas.
9
Cables
Connecting cables must not be put where they can become damaged or
where they can be dangerous by personnel tripping on them.
10
Thermal Control
System
Energized devices always become hot during operation. If you operate this
device in a closed area you must make sure it has sufficient airflow to
keep it at a low temperature.
Also, if worn near the body, you must be careful to give protection the
operator from large temperatures.
11
RF Emission
System
When operating this device please make sure a distance of 20cm is kept
between your device and your body while the device is transmitting.
12
Aircraft Safety
Operating this equipment on board aircraft is not permitted. Operating
radio transmitter equipment in an aircraft can be dangerous to navigation
and other systems.
Table 8-1 Cautions and Warnings
