PRORXD Broadcast Receiver User Guide
Commercial in Confidence
Broadcast Solutions, HD/SD Products,
PRORXD
100167
Revision: 7.0
Commercial in Confidence
Page 7-63
No
Property
Range
Description
5
Enable
Select or Clear
Switches the streaming item on or off.
Note: The PRORXD must be licensed for
Streaming. If it is not, it is not possible to
switch Streaming on. Also, for correct
streaming operation, a correct Gateway
address in the IP subnet range must be set
manually or through DHCP.
6
Streamer Select
You select the source that will give the stream
from this drop-down box.
Demod 1 for example means the stream will
come from the first receiver channel.
7
Multicast
Address
Default – 224.2.128.12
This text box enables you to change the
multicast address used by the unit.
It is also possible to Unicast by specifying an
applicable destination IP address in the local
subnet range.
8
Multicast Port
10000
Range available is 1-65535
Protocols like TCP or UDP use port numbers in
the header to point traffic around the network.
Low port numbers are used by computer
systems for predefined tasks. For example
SMPT (for your email service) uses port 25.
A good rule is to use numbers above 10,000 to
stop confliction with existing services.
When you set up a port number on many
computers on a network they will all listen for
packets directed to that port.
The default values are 10000 and 10002.
9
Multicast
Service Name
Up to 20 ASCII characters.
The defaults are MPEG2-TS and MPEG2-TS2.
This is an identifier for the service.
10
Multicast ToS
The importance of the Multicast can be set
here.
Table 7-18 Streaming Settings Pane Key
