PRORXD Broadcast Receiver User Guide
Commercial in Confidence
Broadcast Solutions, HD/SD Products,
PRORXD
100167
Revision: 7.0
Commercial in Confidence
Page 7-70
No
Property
Range
Description
7
Remux Bitrate
5.00
If you have selected Remux in ASI Output (item 5
in this table) earlier, then this field will be in
operation and will let you to set the bitrate for the
Remux stream leaving the ASI Output port.
You might have remuxed two video signals
together which you are then planning to transmit
forwards. You could configure the Remux Bitrate to
align with your transmitter bandwidth then make
sure the two signals you are going to Remux will fit
into that space.
For correct operation, the bitrate must be the same
or higher than the combined bitrate of all input
streams.
Table 7-21 General Pane Key
Step 6: Configure the IFB Pane
Figure 7-29 IFB Pane
No
Property
Range
Description
1
IFB Enable
Select or Clear
When selected the Interruptible fold back system is
switched on.
The IFB is a special intercom circuit that consists
of a mix-minus program feed sent to an earpiece
worn by presenter via IP (audio that is being “fed
back” to presenter) that can be interrupted and
replaced by a television producer's or director's
intercom microphone.
2
Tx IP Address
Example:
192.168.2.65
This is the IP Address of the device to which you
are sending the fold back. This device is usually be
located with the presenter.
