Doosan GL08K, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 206

Safety Regulations & Specifications - 3 -
1.1.3. To prevent damage to engine and premature wear
1) Never demand more of the engine than it was designed to yield for its intended purpose.
Detailed information on this can be found in the sales literature. Electric control unit must not be
adjusted without prior written permission of DOOSAN.
1) If faults occur, find the cause immediately and have it eliminated in order to prevent more serious of
damage.
2) Use only genuine DOOSAN spare parts. DOOSAN will accept no responsibility for damage resulting
from the installation of other parts which are supposedly “just as good”.
3) In addition to the above, note the following points.

Never let the engine run when dry, i.e. without lube oil or coolant.

Pay attention to cleanliness. The Diesel fuel must be free of water.

Use only DOOSAN approved service products (engine oil, anti-freeze and anticorrosion agent)

Refer to the subjects of recommendation of the fuel.

Have the engine maintained at the specified intervals.

Do not switch off the engine immediately when it is warm, but let it run without load for about 5
minutes so that temperature equalization can take place.

Never put cold coolant into an overheated engine.

Do not add so much engine oil that the oil level rises above the max. marking on the dipstick. Do
not exceed the maximum permissible tilt of the engine.

Always ensure that the testing and monitoring equipment (for battery charge, oil pressure,
coolant temperature) function satisfactorily.

Do not let the raw water pump run dry, If there is a risk of frost, drain the pump when the engine
is switched off.
1.1.4. To prevent pollution
1) Engine oil, filter elements, fuel filters

Take old oil only to an oil collection point.

Take strict precautions to ensure that oil does not get into the drains or into the ground. The
drinking water supply could be contaminated.

Filter elements are classed as dangerous waste and must be treated as such.
2) Coolant

Treat undiluted anti-corrosion agent and / or antifreeze as dangerous waste.

When disposing of spent coolant comply with the regulations of the relevant local authorities.