Docomo FOMA N601i, Руководство пользователя

Страница: 436 / 469

30
Dial-up creating function
Select the added/edited access point (APN) on the “
接続先（
APN
）設定
” (Set up Access point (APN))
screen and click “ ダイヤルアップ作成 ” (Create dial-up).
When the screen for writing into the FOMA terminal appears, click “ はい ” (Yes). After finishing writing into the
FOMA terminal, the “ パケット通信用ダイヤルアップの作成 ” (Create dial-up for packet communication)
appears.
Enter any connection name you want and click “
アカウント・パスワードの設定
” (Set up Account/Password).
Enter the user name and password, select an accessible user, then click “OK”. You can leave the user name
and password blank for mopera U or mopera.
If your provider has given you instructions for setting IP and DNS information, click “
詳細情報の設定
”
(Detailed settings) on the “
パケット通信用ダイヤルアップの作成
” (Create dial-up for packet communication)
screen, register necessary information and click “OK”.
After entering the settings, click “FOMA
端末へ設定を書き込む ” (Write settings into FOMA terminal), confirm
overwriting and start writing.
Setting up Dial-up Network
This section describes how to set up a dial-up connection for packet communication / 64K data
communication without using the FOMA PC setting software. The flow of operation is described
below.
d
It is unnecessary to set up the dial-up network for 64K data communication. Go on to “Setting up
Dial-up” (p.37).
About AT commands
d
AT commands are commands for modem control. The FOMA terminal complies AT commands and
supports some enhanced commands and its own AT commands.
d
Entering an AT command allows you to set or confirm (display) the detail settings and the contents
of the settings for the “Data communication” and FOMA terminal.
Checking the COM port
d
To set up the access point (APN), you need to specify the COM port number assigned to “FOMA
N601i” (Modem) built in after installing the N601i communication setting file (drivers). This section
describes how to confirm the COM port number. The COM port confirmed here will be used in the
access point (APN) set up (p.33).
d
Preparation
1
Connect the FOMA USB Cable (optional) to the FOMA terminal
2
Turn on the FOMA terminal, then connect the FOMA USB Cable
connected to the FOMA terminal to your PC
NOTE
d
The APN settings (the access point for FOMA packet communication) are stored in the FOMA terminal.
Therefore, the APN must be registered again if you connect to another FOMA terminal.
d When continuously using the dial-up setting created on the PC, register the same APN setting (cid setting)
number with the FOMA terminal.