Dionex ICS-3000, Руководство оператора

Страница: 224 / 392

ICS-3000 Ion Chromatography System
208
Doc. 065031-04 1/08
•
EluGen cartridge electrical connection is open
1. Tug gently on the EluGen cartridge electrical cable; the locking connector
should hold the cable in place (see Figure 2-8 ).
2. If the electrical cable is fully seated but the problem persists, the cartridge
is defective and must be replaced (see Section 9.12 ).
•
EluGen cartridge input electrical connection has shorted out
Replace the EluGen cartridge (see Section 9.12 ).
•
Electrical error
The EG current and/or voltage may have become unstable. Contact Dionex
for assistance.
NOTE The ICS-3000 Ion Chromatography System electronics
components cannot be serviced by the user.
8.21 EG POWER LED Fails to Light
•
No power
Check that the
POWER
button on the front of the EG is turned on.
Check that the EG main power switch (on the rear panel) is turned on.
Check that the main power cord is plugged into both the EG rear panel
connector and the power source. Check that the wall outlet has power.
If the
POWER
LED still fails to light, contact Dionex for assistance.
8.22 Liquid Leaks in the EG
•
Leaking fitting
Locate the source of the leak. Tighten or replace liquid line connections as
needed (see
Section 9.10 ).
•
Blocked or improperly installed waste line
Check the EG waste lines to be sure they are not crimped or otherwise
blocked. Make sure the lines are not elevated at any point after they exit the
EG.