Dionex ASE 100, Руководство оператора

Страница: 111 / 150

Doc. 031842-01 5/02
B-1
B • Installation
B.1 Facility Requirements
_
Make sure the ASE 100 installation site meets the electrical and
environmental specifications listed in Appendix A.
_
The ASE 100 requires a grounded, single-phase power source of from 100 to
240 Vac and 50/60 Hz.
_
The ASE 100 oven voltage setting is controlled by two switches on the rear
panel power supply. The switch settings must match the voltage from the
power source at the ASE 100 installation site. The switches are factory-set for
voltages between 220 and 240 Vac. If the voltage from your power source is
between 100 and 120 Vac, change the switch settings (see Section B.2.2).
_
A source of 99.9% pure nitrogen gas, regulated to between 1.03 and 1.38 MPa
(150 and 200 psi); 1.03 MPa (150 psi) is recommended. Applications that use
a very clean baseline electron capture detector (ECD) may require UHP
(ultra-high purity) gas.
_
Install the ASE 100 on a sturdy workbench at a height that allows convenient
viewing of the front panel display. Allow at least 6 cm (2.5 in) of free space
behind the ASE 100 for connections and ventilation.
Lift the ASE 100 only from the bottom and/or sides of the instrument.
If the system is lifted from the front, the drip tray may slide forward.
Use caution when lifting the ASE 100: it weighs 34 kg (75 lb).
Ne soulevez le ASE 100 que par le fond ou les côtés. Soyez prudent
lorsque vous soulevez le ASE 100: il pèse 34 kg.
Wenn Sie den ASE 100 anheben oder bewegen möchten, greifen Sie
bitte unter den Boden oder heben Sie das Gerät an den Seiten an.
Seien Sie vorsichtig, wenn Sie den ASE 100 anheben. Das Gerät wiegt
34 kg.