Dionex ASE 100, Руководство оператора

Страница: 103 / 150

5 • Service
Doc. 031842-01 5/02
5-33
11. Lift the lower AutoSeal tip out of the support tube located on top of the air
cylinder shaft (see Figure 5-17).
12. Note the indentation along the top edge of the support tube, where it meets the
lower AutoSeal tip (see Figure 5-17). Insert the tip of a small flathead
screwdriver into the indentation and twist the screwdriver just enough to raise
and loosen the lower tip.
13. Hold the solvent line securely with a 1/4-inch wrench, to prevent it from
moving; at the same time, use a 3/8-inch wrench to loosen the lower tip.
Remove the tip and discard it.
14. Screw the new AutoSeal tip (P/N 056641) onto the end of the solvent line.
While holding the solvent line securely with a 1/4-inch wrench, use a 3/8-inch
wrench to tighten the new AutoSeal tip.
15. Push the new AutoSeal tip into the support tube on top of the air cylinder.
16. Route the solvent outlet line through the vertical guide and reinstall the
Phillips screws in the guide.
Figure 5-17. Support Tube for Lower AutoSeal Tip