Dionex ASE 100, Руководство оператора

Страница: 63 / 150

4 • Troubleshooting
Doc. 031842-01 5/02
4-3
Error 005 Cell pressure threshold exceeded.
Cause: A blockage in the system.
Action: Run a rinse cycle (see Section 3.1.7). If the rinse runs
successfully, the extraction cell may be plugged. Replace the
cell filter (see Section 3.1.4) and the stainless steel cell frit (see
Section 5.1).
Action: If the rinse is not successful, there may be a blockage in the
solvent lines. Contact Dionex for assistance.
Error 006 Collection bottle full.
Cause:
The collection bottle is full.
Action:
Empty the collection bottle. If the error message reappears,
contact Dionex for assistance.
Error 007 Collection bottle not detected.
Cause: The collection bottle is not installed, or the sensor failed to
detect the bottle.
Action: Install the collection bottle (with the bottle cap screwed on)
and toggle the needle switch to the
DOWN
position
(see
Section 3.1.6). If the error message reappears, contact Dionex
for assistance.
Error 008 Cell not detected.
Cause: No cell is installed, or the sensor failed to detect the cell.
Action: Install the appropriate cell (see either Section 3.4, Step 8, or
Section B.2.6.) The installation procedure for extraction cells
and rinse cells is identical. If the error message reappears,
contact Dionex for assistance.