Diamond Products CORE CUT CC9074DC-36, Руководство оператора, Страница: 58 / 72

MAINTENANCE
Installing the Inner Blade Flange
1. Inspect the inner flange for damages.
Clean or replace damaged components as
necessary.
2. Align the flange with the blade shaft key
and place the flange onto the blade shaft.
3. Apply Loctite 262 (red) or an equivalent to
the setscrew threads.
4. Tighten the setscrew(s) into the back of the
inner flange to secure.
Removing the Inner Blade Flange
1. Remove the setscrew(s) from the back of
the inner flange using an Allen wrench.
2. Carefully remove the flange from the blade
shaft.
Maximum Cutting Depth Stop Bolts
Always adjust the maximum cutting depth stop
bolts when changing to a larger flange size to
avoid damaging the blade flanges.
1. Raise the saw to gain access to the
maximum cutting depth stop bolts
underneath the frame base.
WARNING
Raise the saw to a proper height for
access when working underneath the
saw. Use chocks to block the wheels,
and fit blocks or jacks under the frame edges
at the front and back of the frame
.
2. Loosen the jam nut on both bolts.
3. Turn the bolts counterclockwise to
decrease the maximum cutting depth, or
turn the bolts clockwise to increase the
maximum cutting depth.
NOTE: Both bolts must be the same length
when finished
.
Maximum Depth Stop Bolt
4. Bottom out the jam nut on each bolt with
the frame base to secure the bolts.
5. Remove all tools from the area and lower
the saw completely. The blade flanges
must be at least 1/4” from the ground to
prevent component damage.
6. Readjust the depth bolts as necessary.
NOTE: Make sure both skid plates on the front
of the saw are in the correct set of holes in
order to lower the saw completely (refer to
Appendix B)
.
Handlebar Lock Cylinder
The handlebar lock cylinder must be serviced
by Diamond Products if the handlebars can be
moved up or down in excess amounts when
locked in place (movement may feel sluggish).
Send the entire assembly to Diamond Products
to be recharged or pressurized.
Removing the Lock Cylinder
1. Open the rear cover screen.
2. Remove the round 1-5/8” hole plug located
on the lower right hand side of the upright
assembly.
Cylinder Pin Access Plug
58