Diamond Products CORE CUT CC9074DC-36, Руководство оператора, Страница: 40 / 72

MAINTENANCE
Maintenance
General
Failure to read and comply with the
maintenance instructions provided in this
manual prior to performing maintenance may
result in serious injuries and/or death, and may
harm the saw. DO NOT attempt to perform
maintenance on the saw if you are not properly
trained for it, or are not supervised by an
experienced person.
Refer to the CC9074DKV Parts List for
additional information and part diagrams when
performing maintenance tasks. Refer to the
engine manual and manufacturer as the
primary source for all safety, operations, and
maintenance instructions for the engine.
Contact the saw and/or engine manufacturer
with any additional questions.
Remove all necessary guards and access
panels prior to servicing the saw. Replace prior
to operating.
Maintenance Tools
Tools critical for the maintenance of the
machine are provided with the machine and
located on the inside of the upright. A wrench
holder tube is provided on the left hand side
and contains ratcheting 15/16” wrench and a
belt tensioning tool. A 3/8” hex head L-Key is
provided on the right side of the upright.
Pre Maintenance Preparations
•
Ensure the saw is in a safe area to conduct
maintenance.
•
Maintain proper cleanliness of the work
area to minimize personnel injury or
equipment damage.
•
Ensure the saw is sufficiently cool to
conduct any maintenance.
•
Remove the cutting blade prior to starting
any maintenance.
•
Place the saw on a level surface with the
engine turned off and the emergency stop
activated.
•
Ensure there is adequate lighting in the
work area to ensure safety.
•
Ensure all equipment and tools required for
the maintenance task are staged and
available for use.
•
Prior to any maintenance being performed,
know the locations of all safety equipment
such as fire extinguishers, first aid kits, etc.
•
All maintenance shall be performed by
qualified personnel only.
Rear Cover Screen
The rear cover screen is a versatile component
in regards to maintenance of the machine. It
can be opened to gain access to components
within the upright assembly. Or if additional
access is required, it can be quickly removed.
Removal of Rear Cover Screen
1. Rotate the door latches on the cover
screen clockwise and pull back on the
screen.
2. When the screen is clear of obstructions,
slide it to the right to release it from the lift
off hinges.
Installing the Rear Cover Screen
1. Lower the cover screen down until the top
and bottom half of the hinges align.
2. Slide the screen to the left to connect the
hinge assemblies.
3. Push up on the screen and rotate the door
latches counterclockwise to secure.
General Cleaning
The saw must be cleaned after each use and
prior to conducting any maintenance. Ensure
that the saw is cool prior to cleaning. Ensure
affected electrical equipment is properly
covered or de-energized and the display box is
closed prior to cleaning with water or air.
Cleaning Techniques
Various cleaning options can be utilized
depending on the type of cleaning required.
High pressure washers and a mild detergent
will work the best. Compressed air and low
pressure water can also be utilized where
required.
CAUTION
Care must be taken when using high
pressure water and compressed air to
conduct any maintenance or cleaning.
High pressure water and compressed air
can cause injury to personnel or damage
to equipment if not used properly.
40