Diamond Products CORE CUT CC9074DC-36, Руководство оператора, Страница: 46 / 72

MAINTENANCE
25 Hour Service
Inspect Belts
Inspect all belts daily for tension or wear.
Re-tension or replace as required in
accordance with the “Jackshaft Drive Belts”
and “Blade Drive Belts” sections located in the
“Regular Maintenance” section of this manual.
Lubricate the PTO
1. Swing the cover plate on the belt guard
away enough to expose the front face of
the PTO.
2. Add three pumps of grease to the PTO
using the grease fitting located on the PTO
face.
PTO Grease Fitting
50 Hour Service
Drain the Fuel/Water Separator Filter
Inspect the fuel/water separator and drain as
necessary. The unit is located on the left side
of the saw near the engine starter on the
CC9074DKV.
1. Locate the drainage cap on the underside
of the fuel/water separator.
2. Loosen the cap only enough to allow water
to be discharged from drainage tube.
Do
not remove the cap.
3. When no more water is discharged, re-
tighten the drainage cap.
Fuel/Water Separator
Lubricate the Hydraulic Cylinder Pivot
Pin
1. Ensure the saw is parallel to the ground.
2. Add one pump of grease into the hydraulic
cylinder pivot pin grease fitting located at
the back of the front axle assembly.
Pivot Pin Grease Fitting
46