120
b)
If necessary, change the Port Number. The factory default is 3001 and will usually work in most
cases.
The use of the Subnet Mask and Gateway Address are outside the scope of this manual. If
needed, ask the network administrator for assistance
c)
Click
Update Logger
. The following message displays:
d)
Select
OK
then remove all power to the logger including the USB cable to perform a power cycle.
e)
(Skip this step if Static IP was used.)
If DHCP was selected, reconnect the logger using the USB
cable and use
Logger > Communication > Logger Ethernet Setup…
to determine what IP address
was assigned by the network router to the logger. Note this IP address and disconnect from the
USB connection.
5)
Connect an Ethernet cable from the network into the Ethernet port on the side of the logger.
6)
Click the
Ethernet or Wi-Fi Connection
speed button on the toolbar to reconnect via Ethernet.
The Network Connect dialog box displays:
7)
Enter the
Network IP
Address
and
Port Number
if it is not automatically populated. Select
OK
to
proceed and establish your Ethernet connection.
NOTE:
If you do not know your
Network IP Address
or
Port Number
, click the
Scan
button on the
Network Connect window. ELOG will scan the network for loggers and display them in the Logger
Selection dialog box. Look for the serial number
of the logger to determine which connection point is
yours. The logger’s serial number can also be found on the back of the logger. Select your logger in the
Logger Selection dialog box and click
OK
, and then
OK
again in the Network Connect window.
www.
.com
1.800.561.8187
Содержание ELITEpro XC
Страница 58: ...58 Typical Single Phase 2 Wire Setup Diagram www com information itm com 1 800 561 8187 ...
Страница 59: ...59 Typical Single Phase 3 Wire Setup Diagram www com information itm com 1 800 561 8187 ...
Страница 60: ...60 Typical 3 Phase 3 Wire Delta Setup Diagram www com information itm com 1 800 561 8187 ...
Страница 61: ...61 Typical 3 Phase 4 Wire Wye Setup Diagram www com information itm com 1 800 561 8187 ...