Dell PowerConnect J-SRX100, Руководство по оборудованию, Страница: 78 / 158

Figure 17: Connecting to the Ethernet Port on a J-SRX100 Services Gateway
1.
From the management device you use to access the J-Web interface (such as a PC
or a laptop), verify that the address of the port you connect to is set to one of the
following values:
• Ethernet address on the 192.168.1.0/24 subnetwork other than 192.168.1.1
• Ethernet address from a DHCP server
2.
Plug one end of the CAT-5e (Ethernet cable) into the Ethernet port on the management
device.
3.
Connect the other end of the Ethernet cable to the built-in Fast Ethernet port (any of
the ports
fe-0/0/1
to
fe-0/0/7
) on the services gateway.
4.
Wait until the
Status
LED on the front panel of the services gateway turns solid green.
5.
Turn on the power to the management device. The services gateway assigns an IP
address to the management device within the
192.168.1.0/24
subnetwork if the
management device is configured to use DHCP.
NOTE: After connecting the management device to the services gateway,
the DHCP server process on the services gateway will assign an IP address
automatically to the management device. Ensure that the management
device acquires an IP address on the 192.168.1.0/24 subnetwork (other
than 192.168.1.1) from the device.
6.
From the management device, open a Web browser and enter the IP address
192.168.1.1
in the address field if the management device is configured using the DHCP.
7.
Configure basic settings for your services gateway.
64
PowerConnect J-SRX100 Services Gateway Hardware Guide