Dell PowerConnect J-SRX100, Руководство по оборудованию, Страница: 69 / 158

Related
Documentation
Connecting the J-SRX100 Services Gateway to the Power Supply on page 51
•
•
Connecting and Organizing Interface Cables to the J-SRX100 Services Gateway on
page 52
•
J-SRX100 Services Gateway General Safety Guidelines and Warnings on page 101
•
Powering On and Powering Off the J-SRX100 Services Gateway on page 55
•
Using the Reset Config Button on the J-SRX100 Services Gateway on page 93
•
Changing the Reset Config Button Behavior on the J-SRX100 Services Gateway on
page 94
Powering On and Powering Off the J-SRX100 Services Gateway
This topic describes the following procedures:
• Powering On the J-SRX100 Services Gateway on page 55
•
Powering Off the J-SRX100 Services Gateway on page 55
Powering On the J-SRX100 Services Gateway
To power on the services gateway:
1.
Ensure that you have connected the power supply to the device.
2.
Insert the plug of the power supply adapter into an AC power source receptacle.
3.
Turn on the power to the AC power receptacle.
The device starts automatically as the power supply completes its startup sequence.
The Power LED lights during startup and remains on steadily when the device is operating
normally.
NOTE: After the power supply is turned on, it can take up to 60 seconds for
status indicators—such as the Status and Power LEDs—to show that the
power supply is functioning normally. Ignore error indicators that appear
during the first 60 seconds.
NOTE: If the system is completely powered off when you turn on the power
supply, the device starts as the power supply completes its startup sequence.
If the device finishes starting and you need to power off the system again,
first issue the CLI
request system power-off
command.
Powering Off the J-SRX100 Services Gateway
You can power off the services gateway in one of the following ways:
55
Chapter 9: Connecting, Grounding, and Powering On the J-SRX100 Services Gateway