degdrive DGI900, Руководство пользователя

Страница: 173 / 251

173
5
：
Zero-speed running
（
no output at stop
）
If the AC drive runs with the output frequency of 0, the terminal becomes ON. If the AC drive
is in the stop state, the terminal becomes OFF.
6
：
Motor overload pre-warning
The AC drive judges whether the motor load exceeds the overload pre-warning threshold
before performing the protection action. If the pre-warning threshold is exceeded, the
terminal becomes ON. For motor overload parameters, see the descriptions of PA.00 to
PA.02.
7
：
AC drive overload pre-warning
The terminal becomes ON 10s before the AC drive overload protection action is performed.
8
：
Set count value reached
：
The terminal becomes ON when the count value reaches the
value set in PE.08.
9
：
Designated count value reached
：
The terminal becomes ON when the designated value
reaches the value set in PE.09.
10
：
Length reached
：
The terminal becomes ON when the detected actual length exceeds
the value set in PE.05.
11
：
PLC cycle complete
：
When simple PLC completes one cycle, the terminal outputs a
pulse signal with width of 250 ms.
12
：
Current running time reached
：
If the current running time of the AC drive exceeds the
time set in P2.51, the terminal becomes ON.
13
：
Frequency limited
If the set frequency exceeds the frequency upper limit or lower limit and the output