DCT Antares SB, Руководство пользователя

Страница: 86 / 238

4.5. *EVENT MACHINE
ID Signal Description
A00 - A09 Destination Points’ state True when the IP address/port defined on the corre-
sponding
Destination Point’s index is accepting a TCP
connection or when using UDP (i.e. the TCP/UDP
socket is open). See the
XADP
message.
B00 - B04 Battery ) True when the unit’s back-up battery level is above the
value defined with the
XAGB
message.
C00 - C19 Counters, Timers, Dist) True when the corresponding counter reaches its de-
fined threshold value. See the
GC
message.
D00 - D04 ADC ) True when the ADC input voltage level is above the
value defined with the
XAGA
message.
E00 - E49 Event Tr) True when the corresponding event trigger is True . See
the
ED
message.
F00 Ignition True when the ignition input of the unit is on.
F01 GPS Fix True when doing GPS fixes.
F02 GSM/GPRS Roaming True when the unit is Roaming on GSM/GPRS.
F03 GSM-Registered True when the unit is registered in the GSM network.
F04 GPS Antenna Feed-line fault Indicates a short on the GPS antenna cable.
F05 GPRS-Registered True when the unit is registered on the GPRS network.
F08 GPRS-Attached True when the unit is attached to the GPRS network.
F09 MDT PAD Mode True when the unit is in MDT PAD mode. See the
MT
message
F10 PAD message True when an MDT message is received on the serial
port when PAD mode is ON. See the
MT
message
F11 Woke-Up True when the unit wakes-up after sleep power mode.
Immediately reset after the first events’ evaluation. See
the
XAPM
message
F12 12volts/24volts detector True when the main supply voltage is above 16 volts.
F13 Power True when the unit’s main power supply is on.
G00 - G07 General Purpose Input
Outputs(*)(-).
These signals are true when the corresponding GPIO is
true. See the
SS
and
GF
messages.
IP1 - IP4 Inputs. True when the corresponding input is on. See the
SS
message.
J00 - J04 Heading Deltas. True when the vehicle’s heading change is greater than
the corresponding heading change threshold. The sig-
nal is immediately reset after evaluation to achieve a
turn-by-turn report. See the
SXAGH
message.
R00 - R29 R) True when the vehicle is inside the corresponding re-
gion. See the
GR
message
RST Software reset This signal is used do detect a firmware reset. It is set
to true every time there is a software reset and it is
immediately reset after the first events’ evaluation.
The table continues on the next page.
84