dataTaker DT80, Руководство пользователя

Страница: 211 / 417

UM-0085-B09 DT80 Range User Manual Page 211
RG
To load the SIM card:
1.
Locate the SIM card slot on the right hand side panel
2.
Slide the plastic locking tab to the left, if required, to expose the full width of the slot
3.
Position the SIM card so the edge with the diagonally cut corner is facing inward and the gold contacts are
facing up. Slide the SIM into the slot until it clicks into place
4.
Slide the locking tab to the right to lock the SIM in place. The SIM will not be recognised unless this is done.
To remove the SIM card:
1.
Slide the locking tab to the left
2.
Press the SIM in slightly (you may need a fingernail or small screwdriver), until it pops out.
Warning: Be sure that you are aware of the risks and restrictions for operating a radio transmitting device such as the
DT80
modem.
See
Safety Information (P414)
for more details.
Configuring the Integrated Modem
Automatic Configuration
By default, the
DT80
will attempt to automatically configure the following settings:
• Access point name (APN), and account name/password if required
• Email (SMTP) server name, and account name/password if required
The
DT80
auto-configuration feature works by looking up pre-defined settings based on the mobile carrier that issued the
SIM. Be aware that automatic configuration might not be possible if:
• the
DT80
does not recognise the mobile carrier that issued the SIM card. In this case fixed default settings will
be used. Internet access will not be available, because no valid APN will have been set; you will need to
configure this manually, as discussed below
• the carrier is recognised, but the SIM is not set up to use the "standard" plan from that carrier. Internet access
may be available but some features might not be available. For example, the actual SIM plan might not include
access to an SMTP server, in which case the SMTP server will need to be reconfigured to use a third party
email provider
Manual Configuration
In order to manually configure the integrated modem, it will be necessary to connect to the
DT80
using an alternative
communications medium, e.g. Ethernet or USB. You can then either:
• directly enter the profile commands described here, or
• use the
dEX
Configuration Builder to generate a configuration that contains the required commands, then save
it to the logger
In dEX , most of the required modem configuration is done on the Modem page. To reach this page, click on the logger
model name at the top left, then select Modem from the list of categories. See
Figure 83
.
Figure 83: Modem configuration page