Danfoss VLT HVAC, Руководство по программированию

Страница: 19 / 99

Motor Set-up
The Quick Menu Motor Set-up guides through the needed
motor parameters.
No & Name Range Default Function
0-03 Regional
Settings
[0] Interna-
tional
[1] US 0
1-20 Motor
Power r
0.12-110kW/
0.16-150hp Size related Enter motor
power from
nameplate data
1-22 Motor
Voltage
50.0 - 1000.0V Size related Enter motor
voltage from
nameplate data
1-23 Motor
Frequency
20.0 - 400.0Hz Size related Enter motor
frequency from
nameplate data
1-24 Motor
Current
0.01 -
10000.00A Size related Enter motor
current from
nameplate data
1-25 Motor
Nominal Speed
100.0 - 9999.0
RPM Size related Enter motor
nominal speed
from nameplate
data
4-12 Motor
Speed Low
Limit [Hz]
0.0 - 400Hz 0.0Hz Enter the
minimum limit for
low speed
4-14 Motor
Speed High
Limit [Hz]
0.0 - 400HZ 65
3-41 Ramp 1
Ramp up Time
0.05 - 3600.0 s Size related Ramp up time
from 0 to rated
1-23 Motor
Frequency
3-42 Ramp 1
Ramp Down
Time
0.05 - 3600.0 s Size related Ramp down time
from rated
1-23 Motor
Frequency
to 0
1-73 Flying
Start
[0] Disabled
[1] Enabled 0 Select Enable to
enable the
frequency
converter to catch
a spinning motor
Changes Made
Changes Made lists all parameters changed since factory
setting. Only the changed parameters in current edit-setup
are listed in changes made.
If the parameter's value is changed back to factory setting's
value from another different value, the parameter will NOT
be listed in Changes Made.
1. Press [MENU] key to enter the Quick Menu until
indicator in display is placed above Quick Menu.
2.
Press [
▲
] [
▼
] to select either FC101 wizard, closed
loop setup, motor setup or changes made, then
press [OK].
3.
Press [
▲
] [
▼
] to browse through the parameters in
the Quick Menu.
4. Press [OK] to select a parameter.
5.
Press [
▲
] [
▼
] to change the value of a parameter
setting.
6. Press [OK] to accept the change.
7. Press either [Back] twice to enter “Status”, or press
[Menu] once to enter “Main Menu”.
2.3.4 Main Menu
[Main Menu] is used for programming all parameters. The
Main Menu parameters can be accessed immediately unless
a password has been created via
0-60 Main Menu Password .
For the majority of VLT HVAC Basic Drive applications it is not
necessary to access the Main Menu parameters but instead
the Quick Menu provides the simplest and quickest access to
the typical required parameters.
The Main Menu accesses all parameters.
1. Press [MENU] key until indicator in display is placed
above “Main Menu”.
2.
Use [
▲
] [
▼
] to browse through the parameter
groups.
3. Press [OK] to select a parameter group.
4.
Use [
▲
] [
▼
] to browse through the parameters in
the specific group.
5. Press [OK] to select the parameter.
6.
Use [
▲
] [
▼
] to set/change the parameter value.
[BACK] is used to go one level back.
How to Programme VLT HVAC Basic Drive Programming Guide
18 MG.18.B1.02 - VLT
®
is a registered Danfoss trademark
2 2