SONO 3500 CT
Operating Instructions, 07/2019, VI.SH.P2.02
63
Troubleshooting/FAQs
9
9.1
Error codes
A list of errors is available in SIMATIC PDM (active errors are check-marked). Access to this
list is gained via "Device"
→ "Device Status". In the figure below, error codes F 1, F 2 and F 5
are active.
Figure 9-1
List of errors shown in PDM
Table 9- 1
Error codes shown in the display and in PDM
Error
code
Error
Remedy/Cause
Blank
display
Battery plug not connected, or battery
empty, mains power interrupted
•
Check flowmeter version. Battery version not
able to run on mains power
•
Battery empty: Replace battery pack
•
Battery plug not plugged into the transmitter,
see Battery replacement (Page 53)
F 1
Path 1 (upper path) not measuring
No water in upper part of pipe and/or cables or
transducer 1A or 1B defective
F 2
Path 2 (lower path) not measuring
No water in lower part of pipe and/or cables or
transducer 2A or 2B defective
F 3
Internal software failure
Contact your customer support
F 4
Internal software failure
Contact your customer support
F 5
Power supply warning
•
Mains power fails
•
Replace battery pack
F 6
Flow exceeds preset flow rate in unit
(max. speed 10 m/s)
Flowrate too high
F 7
Pulse output A overflow
Pulse output exceeds 100 Hz or 50% duty cycle
Содержание SONO 3500 CT
