The size of the Dead Band is defined by either P1 or P2 as shown in the graph below.
Thus, a reference endpoint of P1 = (0 V, 0 RPM) will not result in any dead band, but a reference endpoint of P1 = (1 V, 0 RPM), for example, will result
in a -1 V to +1 V dead band in this case, provided that the end point P2 is placed in either quadrant 1 or quadrant 4.
Case 1: Positive Reference with Dead band, Digital input to trigger reverse
This case shows how a reference input with limits inside Min – Max limits clamps.
FC 300 Design Guide
3 Introduction to AutomationDrive FC 300
MG.33.BC.22 - VLT
®
is a registered Danfoss trademark
3-13
3