Daikin VRV III, Руководство по обслуживанию, Страница: 467 / 567

Troubleshooting (OP: Central Remote Controller) SiUS34-801A_b
452 Troubleshooting
Troubleshooting
Caution
Be sure to turn off power switch before connect or disconnect connector,
or parts damage may be occurred.
NO
Correct the setting of the
combination of master and
slave units, and then reset
the power supplies of every
central equipment.
Reset the power supplies of
every central equipment.
Replace the central
equipment.
Central equipment: Normal
It is supposed that the
malfunction results from
external factors (e.g. noises)
from other equipment.
NO
YES
YES
NO
Did the
malfunction
occur while in the first test
run using the intelligent
Touch controller?
Is the
Master/Slave setting of the
central equipment
correct?
Was the
central equipment
connected once, and then
disconnected, or was additional
central equipment
installed?
Is the "
MC
"
displayed again?
With "
MC
"
displayed
Without "
MC
"
displayed
Is the Master/
Slave setting of the
central equipment
correct?
YES YES
If the intelligent Touch
controller is used, correct the
setting of the combination of
master and slave units again
while in DIII-NET test run
mode, referring to the
Master/Slave setting table.
NO
Turn ON the power supply of
the central equipment with
"
MC
" displayed once again.
Reset the power supplies of
every central equipment.
Be sure to
refer to the
Master/
Slave
setting
table.
Check 9
Check 9
Check 8
: Referring to the information on P468.
Check 8
: Referring to the information on P467.
∗
1
∗
1