Contax SW 2524, Руководство пользователя, Страница: 94 / 322

Installation
3–12 976-0043-01-01
Wall Mounting
using Plywood Alternatively, a half sheet (4 ft x 4 ft) of ¾-inch plywood can also be used
as a backing, with the inverter mounted directly to the plywood using ¼-
inch diameter lag bolts and washers. The plywood must span three studs
for adequate support.
1. Drill the mounting holes in the plywood sheet by one of the following
methods. Be sure to use all the mounting holes and keyhole slots for
mounting.
a) Using the measurements from
Figure 3-3 drill out the mounting
hole locations for the inverter.
b) Create a cardboard template by tracing around the inverter and
marking the mounting holes and keyhole slots on the cardboard.
Use the cardboard template to locate and drill the mounting holes.
2. Ensure the plywood is securely fastened to the wall before mounting
the inverter on it.
3. With assistance, lift the inverter into position and install it onto the
plywood using ¼ x ¼-inch lag bolts and washers.