Contax SW 2524, Руководство пользователя, Страница: 134 / 322

Navigation
5–2 976-0043-01-01
Navigating the Sine Wave Plus
The Sine Wave Plus is programmed using the control module to access
“User” and “Setup” menus. Navigating through the menus requires an
understanding of the inverter control module (ICM) and its features and
what menus are required to do specific functions and set, or change,
parameters.
The factory default settings may be adequate for most installations. Check
the factory default settings shown on
Table 6-1, “Basic Setup Menu
Default Settings” on page 6–2 and Table 7-1, “Advanced Setup Menu
Headings and Default Settings” on page 7–2 to see if your specific
installation will require changes to these settings.
If your installation will require that the settings be altered, changes can be
made using the features of the inverter control module.
Most installations will require that the user perform the Basic Setup
routine.
The Inverter Control Module (ICM)
The ICM is located on the front panel of the Sine Wave Plus . It’s used to
display status information regarding the operation and performance of the
unit. It is also used to access the “Basic Setup”, “Advanced Setup”, and
“User Menus”. All settings (except for Time of Day) can be saved in non-
volatile memory so they are not lost when DC power is removed from the
inverter.
If a remote ICM is installed, you may do all the same programming from
the remote control module instead.
Figure 5-1 ICM Features
O1A Inverter
OFF SRCH ON CHR
Liquid Crystal
Display (LCD)
Cursor
Push-Buttons
Contrast
Adjustment
Reset Defaults