Colorjet AURAJET II Series, Инструкция по установке и устранению неисправностей

Страница: 57 / 80

Page | 56
AuraJet Series II
e. Replace the Capping Motor by reversely following all the above mentioned steps.
Note
: By following the same procedure, you can also replace the pulley, gear, and belt.
Steps to change the
Wiping motor :
a. Loosen both screws on the Motor Bracket, as shown below:
Fig 69: Loosing the Wiping Motor Screws
Now, the Wiping Motor can easily be removed.
b. Loosen all the four screws available on the back side of the Motor Bracket to remove the motor
from bracket.
c. Remove and replace the Wiping Motor by reversely following the above mentioned steps.
Case 7: Carriage or Motor Belt is Cut OFF
a) Replace the Carriage or Motor belt, if faulty.