Page | 27
AuraJet Series II
7.
Select
the
Fill
option from the list, as shown below:
Fig 22: Selecting the Fill Option
Now, the ink filling process gets started. Observe the process carefully, if ink is not reached to the dampers, then
again check the alignment settings between the Captop and the print head.
Some of the reasons in which you need to adjust the settings between the captop and the print head are given as
follows:
•
Case 1:
When the captop and the print head are not centrally aligned. In such case, loose the screws of
the captop and adjust them (print head and captop) accordingly.
•
Case 2:
When the captop is not seemed to be firmly attached to the print head OR gap is visible between
the print head surface and captop. In such case, you need to edit the value of the
Headbox_Z_SuckPos
option in the clean parameters settings.
Содержание AURAJET II Series
Страница 1: ......
Страница 18: ...Page 17 AuraJet Series II Step 17 Install the sublimation kit If applicable as shown below...
Страница 79: ......
