Colorjet AURAJET II Series, Инструкция по установке и устранению неисправностей, Страница: 59 / 80

Page | 58
AuraJet Series II
Printer Manager Not Showing READY
Reasons:
1. USB cable is loosely connected to the printer
2. USB cable is faulty
3. Printer not initialized
Remedial Actions:
Case 1 : Tighten the USB cable.
Case 2 : Replace the USB cable, if faulty.
Case 3 : Please refer “Printer Not Initialized” section.
Print Stop During Printing
Reasons:
1. USB cable is loose or faulty
2. Open heavy file that can slow down the data transfer
3. Ground wire is disconnected
4. Encoder Scale is having ink stains
5. Encoder Sensor is faulty
6. Pulley teeth wear out or belt is slipping
7. Ripped file is having error
8. Front Glass Door gets activated
9. Data Cable is loose or faulty
Remedial Actions:
Case 1 : Tighten the USB cable or replace it.
Case 2 : Use compatible and small size images for printing.
Case 3 : Connect the ground wire to the system.
Case 4 : Check and replace Encoder Scale.
Procedure:
Steps to replace the Encoder Scale:
a. Remove the shield cover.
b. Loosen the screws which tighten the Encoder Scale, as shown below:
Fig 72: Loosing the Encoder Scale Screw