COBHAM Sea Tel 2400, Руководство по установке

Страница: 71 / 120

Sea Tel 2400 Dual Band C/Ku Configuring The Satellite Modem Interface.
10-1
EAR Controlled - ECCN EAR99
10. Configuring The Satellite Modem Interface.
The configuration setup of an integrated satellite modem to the MXP is accomplished via the Communication Interface
Page (Configuration>Interfaces link on the navigational panel on the left hand side of the screen). In order to access this
page, the user must be logged in as either “Dealer” or “SysAdmin”. The current software load, IMA Ver 105 at the time of
this release) contains 6 commonly used satellite Modems (iDirect, Comtech, Gilat, Hughes, STM, and Viasat) as selectable
presets and is typically a prompted selection when using the new Commissioning Wizard. However, the MXP allows
configuration of a “Custom” modem type. The primary focus of this procedure is to define all of the parameter options
made available to allow the commissioning technician to properly integrate any compatible L-Band Satellite modem.
10.1. Satellite Modem I nterface
1. If not already, log into the system using
the “Dealer” or “SysAdmin” credentials.
2. On the left hand side of the screen, under
Configuration, select the
“Interfaces”
link.
3. On the right side of the screen,
approximately half way down is the
“Modem Lock Mute” section. This section
is where the user, via drop down menu
selection and/or mutually exclusive radio
buttons, defines:
•
Reflector
•
Modem Type
•
Modem I/O
•
Lock Input
•
Block Output