COBHAM Sea Tel 2400, Руководство по установке

Страница: 43 / 120

Sea Tel 2400 Dual Band C/Ku Installation in 144” Radome
4-21
EAR Controlled - ECCN EAR99
Only 2 people are required to sub-assemble the top of
the radome.
1. On a flat surface, adjoin two panels and loosely
install a bolt/nut high, mid and low in the
adjoined flange.
2. Continue adjoining additional panels loosely
installing a bolt/nut high, mid and low on each
flange until all six panels have been loosely
assembled to form the bottom half of the
radome.
3. The person inside now loosely installs the rest of the hardware in all of the flanges. Do
NOT tighten the bolts at this time.
NOTE:
The person who is working inside installing hardware, applying Loctite, tightening hardware
and cleaning the inner flanges will remain inside until the cap and lifting brackets are installed.
4. Assure good horizontal alignment of the panels. Good alignment of the bottom edge of
the panels is important for good seal between the lower and upper panels.
5. To provide a clean caulked seam all around the
panels: apply painters masking tape to the
outside perimeter of each of the panels about
¼“ from the top, bottom, left and right edges
at each flange joint. The tape will be removed
just before the radome caulking has had time
to set.
NOTE: It is extremely important to assure that the
flanges are properly aligned before the bolts are
tightened and kept in alignment as the hardware is
aligned. This is necessary for the inside clearance and
the outside aesthetic appearance of the radome. Please
note this picture shown good alignment as observed
from inside the radome and below a flange with bad
alignment.
Good flange alignment
Bad flange alignment