COBHAM Sea Tel 2400, Руководство по установке

Страница: 41 / 120

Sea Tel 2400 Dual Band C/Ku Installation in 144” Radome
4-19
EAR Controlled - ECCN EAR99
NOTE: It is extremely important to assure that the
flanges are properly aligned before the bolts are
tightened and kept in alignment as the hardware is
aligned. This is necessary for the inside clearance and the
outside aesthetic appearance of the radome. Please note
this picture shown good alignment as observed from
inside the radome and below a flange with bad alignment.
Good flange alignment
Bad flange alignment
4. Set the assembled panels on the base frame
assembly and align the center of the door to be
directly above the AFT marking on the base
frame.
5. Loosely install bolts, fender washers and nuts to
attach the panels to the base frame using the
hardware provided. Do NOT tighten the bolts at
this time.
NOTE: There are eight holes, directly above the legs of
the baseframe, that bolts can NOT be fitted into because
of the leg hardware beneath. These holes should be
plugged, do NOT try to force a bolt into these holes.
6. Continue adjoining additional panels loosely
installing hardware in the mated vertical flanges
and in the horizontal flange to the base pan.
7. Continue until all of the lower radome panels are
in place.