COBHAM Sea Tel 2400, Руководство по установке

Страница: 50 / 120

Installation in 144” Radome Sea Tel 2400 Dual Band C/Ku
4-28
EAR Controlled - ECCN EAR99
36. At the Marine Air Conditioner, cut the cable
ties on the 2 cables that exit the side of the
unit.
37. Unscrew the top cap and compression and
route the AC UNIT INPUT power cable
through them.
38. Connect L1, L2 & GND to the input terminals
as labeled.
39. Tighten the terminals using a small straight
blade screwdriver.
40. Tighten this top cap & compression fitting on
the side of the circuit breaker box.
41. Close the circuit breaker box and reinstall the
mounting screws removed in step 24.
At The Basepan entry Strain Reliefs (step 12, 13 & 17 above);
42. Tighten the cap until the rubber compresses sufficiently to prevent the GROUND cable
from sliding in the body of the strain relief.
43. Tighten the cap until the rubber compresses sufficiently to prevent the PEDESTAL & RF
power cable from sliding in the body of the strain relief.
44. Tighten the cap until the rubber compresses sufficiently to prevent the MARINE AIR
CONDITIONER power cable from sliding in the body of the strain relief.
45. Route the marine air conditioner controller
cable to the Controller mounted on the Aft
end of the sawhorse.
46. Plug the cable into the Controller (on the back
side next to the AZ Post in this picture).
4.6.3. Remove stow Straps
Remove the stow straps from the pedestal and repackage them in the Antenna Stow Kit.
Provide this kit to the responsible person aboard the ship so it can be stored for future use.
4.6.4. ADE Final Checks
Remove all tools, parts and installation debris from inside the radome.
Remove all tools, parts and installation debris from the area around the outside of the radome.