COBHAM Sea Tel 2400, Руководство по установке

Страница: 49 / 120

Sea Tel 2400 Dual Band C/Ku Installation in 144” Radome
4-27
EAR Controlled - ECCN EAR99
NOTE: Marine Air Conditioner - Minimum gauge for the AC Power conductors should not
be smaller than 12 AWG , even for a short cable run.
17. Route the AC Power cable through one of the compression caps, the washer, the rubber
stopper and the body of the strain relief and into the base of the radome.
18. Pull a small amount of excess cable into the radome. To route the power cable to the
circuit breaker box, with a small amount of excess cable as a service loop.
19. Slide the strain relief cap, washer and rubber stopper up into the body of the strain relief.
20. Tighten the cap until the rubber compresses sufficiently to prevent the cable from
sliding in the body of the strain relief.
21. On the INPUT side of the Circuit Breaker Box
22. Unscrew the top cap and compression and
route the Pedestal & RF power cable through
them.
23. Unscrew the bottom cap and compression
and route the Marine Air Conditioner power
cable through them.
Note: Customer must provide adequately sized
pin terminals for the ends of the power
conductors.
24. Open the circuit breaker box and route
Pedestal & RF power cable to the AC input
power terminals.
25. Strip the end of the cable and then strip each
conductor.
26. Install appropriately sized pin terminals on the
ends of the conductors.
27. Connect L1, L2 & GND to the input terminals
as labeled.
28. Tighten the terminals using a small straight
blade screwdriver.
29. Tighten this top cap & compression fitting on
the side of the circuit breaker box.
Note: Customer must provide adequately sized
pin terminals for the ends of the power
conductors.
30. Open the circuit breaker box and route
Pedestal & RF power cable to the AC input
power terminals.
31. Strip the end of the cable and then strip each
conductor.
32. Install appropriately sized pin terminals on the
ends of the conductors.
33. Connect L1, L2 & GND to the input terminals
as labeled.
34. Tighten the terminals using a small straight
blade screwdriver.
35. Tighten this top cap & compression fitting on
the side of the circuit breaker box.