22
PL12EN-1300 2008-03
en03d141.fm, 11.03.2008
Programming
3
the <ENTER> key again. The user interface switches control to the selected unit. When a remote
unit is selected the IP address, station name, and station number of that unit are displayed in the
title bar of all screens.
To return control to the local unit, return to the Navigator menu and use the above procedure, this
time selecting "Local TM Unit" in the Work Cell List dialog.
To add units to the Work Cell List, use the Work Cell screen in Communications.
3.1.3
Password Function
Passwords can be configured to operate in one of two modes: Read Protected or not Read Pro-
tected. Refer to Administration / Password for configuration details
Read Protected: A password is required when selecting a section from the Navigator menu. It is
only required to enter the password once. If the user exits a section with programmable data
(Basic, Standard, Advanced, Communications, Tool Setup) that has been changed, then only the
confirm entry in the password dialog is displayed.
Not Read Protected: No password is required when selecting a section from the Navigator menu.
If the user exits a section with programmable data (Basic, Standard, Advanced, Communica-
tions, Tool Setup) that has been changed, then the password entry dialog will be displayed. If no
password is activated, then only the confirm entry in the password dialog is displayed. Once the
password has been entered, it must be entered each time an appropriate screen is exited.
3.1.4
Print Screen
A Print Screen function is available on all screens. In some cases a Print Screen soft key has
been added that will allow the bitmap to be saved to the floppy disk, disk, or print directly to a
printer (Laser, Inkjet). On screens that do not have this soft key, the user can reach this function
by pressing the "0" key. A dialog box allowing the user to assign a filename will be displayed.
Using the arrow keys, highlight the filename and enter up to 8 characters, then activate Accept to
save to the floppy.
3.1.5
Two Channel Features: General Description (2-Channel V2.xx.xx C2 only)
The user interface is identical to the single-channel configuration. On all screens, the data for the
currently selected tool is displayed. The current tool is selected by entering a 1 or 2 in the "Tool"
edit box. The Tool may be selected from the Run Screen, Basic Application Builder, Standard
Application Builder, or Statistics screens. On screens where there is no Tool edit box, the cur-
rently selected tool is displayed in the blue title bar at the top of the screen. Both tools are always
operable regardless of which tool is currently selected by the user interface.
All editable parameters are set and saved individually for each tool, with the following exceptions:
• Language
• Date/Time
• Passwords
• Field Bus Parameters
• Torque Units
• Run Screen 2-Tool Display Configuration (Auto-select)
• Ethernet protocol, IP addresses and port number
• System Settings/General "Same for both tools" option
(See 3.4.7 Advanced Application Builder / System Settings, page 53)