EXTender 1100A Switch and Remote Module System Administrator’s
Guide
48
Advanced IP Parameters – LAN Address
Prior to the administrator having remote access to the Switch Module and Remote Module
the system IP parameters must be configured. The following is a detailed description of
the programming areas that would be considered “essential” to the proper operation of the
Switch Module and Remote Module. The Switch Module LAN Address configuration
screen is shown below:
Path:
Gateway->Configuration->IP->LAN->Address
Figure 23: Switch Module – LAN Address Configuration Screen
1. Configuring the unit’s IP
Address
– A valid IP address for the Switch Module must be
entered in order for it to operate on the IP network. The IP address should be
obtained from the corporate IT Administrator prior to configuring the Switch Module.
2. Configuring
the
Subnet Mask
- A valid subnet mask for the Switch Module must also
be entered in order for it to operate on the IP network. The subnet mask should be
obtained from the corporate IT Administrator prior to configuring the Switch Module.
3. The
Default Router
– A valid default router address must be entered to reach IP
hosts not on this same IP sub-network. The default router should be obtained from the
corporate IT Administrator prior to configuring the Switch Module.
Document Number: M-1100A-MUC
Version: Rev AG
© Copyright 2008 Citel plc All Rights Reserved
