EXTender 1100A Switch and Remote Module System Administrator’s
Guide
37
►
Refer to page
51
and page
60
for full details.
14. Change the Serial Port default baud rate (9600) to a higher or lower speed depending
on administration requirements. See the Switch Module
Advanced System
Parameters – System
and Remote Module
Advanced System Parameters – System
Settings
sections for full details.
Path:
Gateway (and Remote) ->Configuration->System
►
Refer to page
51
and page
60
for full details.
15. Setup the Remote Module to use the time stamp from the Switch Module for trouble
shooting purposes. See the Remote Module
Advanced System Parameters – System
Settings
section for full details.
Path:
Remote->Configuration->System
►
Refer to page
60
for full details.
16. Enable an Administrator password to ensure that only authorized personnel can
configure the Switch and Remote Module. See the Switch Module ss and Remote
Module ss sections for full details.
Path:
Gateway (and Remote) ->Utilities->System->Set Password
►
Refer to page
52
and page
60
for full details.
An administrator’s password should be set to restrict unauthorized access to the Switch
Module. If the administrator password is lost or forgotten please contact a customer
representative at 1-877-248-3587 or
on how to reset the password.
17. Set the Time and Date to provide accurate time and date stamps for trouble shooting
and system maintenance. See the Switch Module
Path:
Gateway (and Remote) ->Utilities->System->Set
►
Refer to page
52
and page
60
for full details.
The 1100A units do not have a real time clock and the Time and Date (for the Remote
and Gateway Modules) will not remain accurate over long periods of time. The Digital
phone time and date is controlled by the PBX and not affected by the Time and Date
stored on the Remote and Gateway Module.
Document Number: M-1100A-MUC
Version: Rev AG
© Copyright 2008 Citel plc All Rights Reserved
