Configuring Additional Features on the Cisco VGD 1T3 Voice Gateway
Configuring Alarms
70
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Examples
Monitor NFAS groups by entering the show isdn nfas group number command:
Router#
show isdn nfas group 0
ISDN NFAS GROUP 0x0 ENTRIES:
The primary D is Serial0:23.
The backup D is Serial1:23.
There are 2 total nfas members.
There are 24 total available B channels.
The primary D-channel is DSL 0 in state IN SERVICE.
The backup D-channel is DSL 1 in state STANDBY.
The current active layer 2 DSL is 0.
Configuring Alarms
Facility alarms currently monitor the following failure events:
•
Interface down
•
T1 or T3 controller down
•
Modem board failure
•
Redundant power supply (RPS) failure
•
Thermal failure
•
Fan failure
Cisco IOS software polls every second to detect the failure events that you have configured and turns on
an alarm when any one of the failure events is detected. By default, the facility alarm is off. Users have
to configure a facility alarm command to enable monitoring of the failure conditions.
Enter no before the full command to disable any of the alarm commands.
Router(config)#
no facility-alarm detect rps
Command
Purpose
Step 1
Router>
enable
Enters privileged EXEC mode.
Step 2
Router#
configure terminal
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
Router(config)#.
Step 3
Router(config)#
facility-alarm detect
interface
[
interface type
]
[
slot
/
port
]
Turns on the facility alarm when an interface goes
down. Enters the interface type and slot/port
designation.
Step 4
Router(config)#
facility-alarm detect
controller
[
t1
|
e1
|
t3
]
[
slot
/
port
]
Turns on an alarm when the controller goes down.
The slot values range from 1 to 7. The port values
range from 0 to 7 for T1. The port value is always
0 for T3.
Step 5
Router(config)#
facility-alarm detect
modem-board
[
slot
]
Turns on an alarm when the modem board present
in the specified slot fails.
Содержание VGD-1T3
Страница 10: ...Contents x Cisco VGD 1T3 Voice Gateway Software Configuration Guide ...
Страница 14: ...Notices OpenSSL Open SSL Project 4 Cisco VGD 1T3 Voice Gateway Software Configuration Guide ...
Страница 120: ...Configuring Voice over IP Additional Resources 110 Cisco VGD 1T3 Voice Gateway Software Configuration Guide ...
Страница 196: ...Using the Setup Script Where to Go Next 186 Cisco VGD 1T3 Voice Gateway Software Configuration Guide ...