Cisco VGD-1T3, Руководство по настройке программного обеспечения

Страница: 167 / 232

Using Cisco Unified Communications Manager to Configure Transcoding and Media Termination Point
Configuring Transcoding and MTP for the Cisco VGD 1T3 Voice Gateway
157
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Enabling SCCP on the Cisco Unified Communications Manager Interface
Perform this task to enable SCCP on the local interface that the voice gateway uses to communicate with
Cisco Unified Communications Manager.
SUMMARY STEPS
1.
enable
2. configure terminal
3.
sccp ccm {ip-address | dns} identifier identifier-number [port port-number]
[version version-number]
4. sccp local interface-type interface-number
5.
sccp ip precedence value
6. sccp
7.
exit
DETAILED STEPS
Step 3
Ensure that your requirements fall within router
capabilities, taking into account whether your router
supports multiple network modules. If necessary,
reassess performance requirements. Verifies your proposed solution.
Step 4
Install PVDM2s and network modules, as needed (see
the
“Connecting Voice Network Modules” chapter in
the Cisco Network Modules Hardware Installation
Guide, and the
Cisco Network Modules and Interface
Cards Regulatory Compliance and Safety
Information
).
Prepares your system for DSP-farm configuration.
Command or Action Purpose
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.