Cisco VGD-1T3, Руководство по настройке программного обеспечения

Страница: 151 / 232

Using Cisco Unified Communications Manager to Configure MGCP Gateway Support
Configuring MGCP Gateway Support
141
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password when prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
controller t1 slot / ds3 port : ds1 port
Example:
Router(config)# controller t1 3/0:23
Enters controller configuration mode and identifies the
location of the T1 controller.
Step 4
framing { esf | sf | crc4 | no-crc4 | mp-crc4 }
[ australia ]
Example:
Router(config-controller)# framing esf
Specifies the framing type on a T1 PRI line.
• Default is sf (super frame) for T1 lines.
Step 5
linecode { ami | b8zs }
Example:
Router(config-controller)# linecode b8zs
Specifies the line encoding method for the link.
• Default is ami (alternate mark inversion) for T1 lines.
Step 6
isdn switch-type { primary-4ess | primary-5ess |
primary-dms100 | primary-ni | primary-net5 |
primary-ntt | primary-qsig | primary-ts014 }
Example:
Router(config-if)# isdn switch-type primary-5ess
Specifies the ISDN switch type.
Note This command can be entered in either global
configuration mode or interface configuration
mode.
Step 7
pri-group timeslots timeslot-range service mgcp
Example:
Router(config-controller)# pri-group timeslots
1-24 service mgcp
Specifies MGCP as the control protocol used for
backhaul.
Note The controller time slots cannot be shared between
backhaul and other Layer 3 protocols.
Step 8
exit
Example:
Router(config-dial-peer)# exit
Exits controller configuration mode and returns to global
configuration mode.
Step 9
interface serial slot / ds3 port : ds1 port : timeslot
Example:
Router(config)# interface serial 3/0:0
Enters serial interface configuration mode and identifies
the location of the interface.