![background image](http://html.mh-extra.com/html/cisco/vgd-1t3/vgd-1t3_software-configuration-manual_65018068.webp)
Basic Configuration Using the Command-Line Interface on the Cisco VGD 1T3 Voice Gateway
Configuring the Voice Feature Card
58
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Configuring the Voice Feature Card
A voice feature card with one to six PVDM2-64 modules supports different port densities depending on
codec complexity.
The voice feature card should work without specific modifications to the software configuration on these
platforms. However, you might need to upgrade the firmware on the voice feature card, depending on
the software release you are using.
To upgrade the firmware of the voice feature card, follow these steps:
Examples
An example of output from the the show voice dsp version command follows. This output verifies the
firmware upgrade.
Router#
show voice dsp version
IOS-Bundled Default Version Firmware-Type
========================== ======= =============
system:/bundled_fw_image 23.6.0 c5510
On-Flash Dspware-Filename Version Firmware-Type
========================= ======= =============
flash:90110.rbf 9.0.110x c5510
flash:rel90107.rbf 9.0.107x c5510
Command or Action
Purpose
Step 1
Router>
enable
Enters privileged EXEC mode.
Step 2
Router#
configure terminal
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
Router(config)#
.
Step 3
Router(config)#
voice dsp
slot
[
/
dsp
] [
slot
[
/
dsp
]]
Enters voice dsp config mode and specifies the
slot/DSP location or a range of slots/DSPs.
•
For the slot argument, specify a value from 1
to 7 to specify the location of the VFC.
•
For the dsp argument, specify a value from 1
to 24 to specify the location of the DSP.
•
To specify a range, the first two arguments
specify the first slot/DSP in the range. The
second two arguments specify the last
slot/DSP in the range.
•
Where slash marks appear in the command
syntax, they are required.
Step 4
Router(config-voice-dsp)#
firmware location
flash:
filename
Specifies that the firmware is in flash memory and
identifies the file name.
Step 5
Router(config-voice-dsp)#
end
Exits config-voicedsp mode and returns to global
configuration mode.
Step 6
Router(config-voice-dsp)#
Ctrl-Z
Router#
Returns to privileged EXEC mode.
Содержание VGD-1T3
Страница 10: ...Contents x Cisco VGD 1T3 Voice Gateway Software Configuration Guide ...
Страница 14: ...Notices OpenSSL Open SSL Project 4 Cisco VGD 1T3 Voice Gateway Software Configuration Guide ...
Страница 120: ...Configuring Voice over IP Additional Resources 110 Cisco VGD 1T3 Voice Gateway Software Configuration Guide ...
Страница 196: ...Using the Setup Script Where to Go Next 186 Cisco VGD 1T3 Voice Gateway Software Configuration Guide ...