Cisco VGD-1T3, Руководство по настройке программного обеспечения

Страница: 142 / 232

Using Cisco Unified Communications Manager to Configure MGCP Gateway Support
Configuring MGCP Gateway Support
132
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Note When you configure MGCP gateway fallback support, the POTS dial peer must include the
service mgcpapp command and must specify the voice port. For the default session application
to take over during fallback, you must also configure a destination pattern.
Step 2 show dial-peer voice
Use the show dial-peer voice command to verify the configuration of the POTS dial peer, for example:
Router# show dial-peer voice 1000
VoiceEncapPeer1000
information type = voice,
description = `',
tag = 1000, destination-pattern = `',
answer-address = `', preference=0,
numbering Type = `unknown'
group = 1000, Admin state is up, Operation state is down,
incoming called-number = `', connections/maximum = 0/unlimited,
DTMF Relay = disabled,
huntstop = disabled,
in bound application associated: 'mgcpapp'
out bound application associated: ''
dnis-map =
permission :both
incoming COR list:maximum capability
outgoing COR list:minimum requirement
type = pots, prefix = `',
forward-digits default
session-target = `', voice-port = `',
direct-inward-dial = disabled,
digit_strip = enabled,
register E.164 number with GK = TRUE
Connect Time = 0, Charged Units = 0,
Successful Calls=0, Failed Calls=0, Incomplete Calls=0
Accepted Calls = 0, Refused Calls = 0,
Last Disconnect Cause is "",
Last Disconnect Text is "",
Last Setup Time = 0.
Step 3 show voice port
Use the show voice port command to verify that the voice port is operational. The following is sample
output for a T1 PRI backhaul voice port on a Cisco VGD 1T3 voice gateway:
Router# show voice port 4/0:1:23
ISDN 4/0:1:23 - 4/0:1:23
Type of VoicePort is XCC
Operation State is DORMANT
Administrative State is UP
No Interface Down Failure
Description is not set
Noise Regeneration is enabled
Non Linear Processing is enabled
Non Linear Mute is disabled
Non Linear Threshold is -21 dB
Music On Hold Threshold is Set to -38 dBm
In Gain is Set to 0 dB
Out Attenuation is Set to 0 dB
Echo Cancellation is enabled
Echo Cancellation NLP mute is disabled
Echo Cancellation NLP threshold is -21 dB