Cisco VGD-1T3, Руководство по настройке программного обеспечения

Страница: 62 / 232

Basic Configuration Using the Command-Line Interface on the Cisco VGD 1T3 Voice Gateway
Configuring ISDN PRI
52
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
This process varies from provider to provider on a national and international basis. However, some
general guidelines follow:
• Determine if the outgoing B channel calls are made in ascending or descending order. The Cisco IOS
software default is descending order; however, if the switch from the service providers is configured
for outgoing calls made in ascending order, the router can be configured to match the switch
configuration of the service provider.
•
Ask for delivery of calling line identification. Providers sometimes call this CLI, or automatic
number identification (ANI).
• If the gateway will be attached to an ISDN bus (to which other ISDN devices might be attached),
ask for point-to-multipoint service (subaddressing is required) and a voice-and-data line.
Table 2 provides a sample of the channelized T1 configuration attributes you might request for a PRI
switch.
Controller Numbering
The T1 controller numbering convention is slot/port in CLI commands. Feature card slot numbering
starts from the motherboard and works up from left to right. Slot 0 is reserved for the motherboard.
T1 feature card slots are numbered sequentially from 1 to 7. Port numbering is from 0 to 7.
The channelized T3 controller numbering convention is slot/ds3 port in CLI commands. Feature card
slot numbering starts from the motherboard and works up from left to right. Slot 0 is reserved for the
motherboard. Feature card slots are numbered sequentially from 1 to 7. Port number value is always 0.
Under the channelized T3, the T1 channel numbering convention is slot/ds3 port:ds1 port in CLI
commands. The port number is always 0 for the CT3 card. The DS1 port numbering values range from 1
to 28.
Table 2 Channelized T1 Configuration Attributes
Attribute Value
Line format Extended super frame (ESF) format
Line coding Binary 8-zero substitution (B8ZS)
Call type 23 incoming channels and 23 outgoing channels
Speed 64 kbps
Call-by-call capability Enabled
Channels 23 B + D
Trunk selection sequence Either ascending order (from 1 to 23) or descending order (from 23 to 1)
B + D glare Yield
Directory numbers Only 1 directory number assigned by service provider
SPIDs required? None