Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-20
OL-7821-05
•
To specify
Not-Operational
status after abnormal boot, press
Enter
.
•
To specify
Operational
status after abnormal boot, type
1
and press
Enter
.
Enter admin status of the SCe after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
The following examples present the procedure for configuring the topology-related parameters for
various topologies. Refer the
Topology Configuration Summary Table
(on page
3-9
) for a
summary of appropriate values for the parameters for each topology.
E
XAMPLE
1:
Following is a sample topology configuration for a topology using an external switch.
All other parameter values are automatically assigned by the system as follows:
•
Link bypass mode on-failure — Bypass
•
Admin status of the SCE after abnormal boot — Operational
Would you like to enter the Topology configuration menu? [no]:
y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
2
E
XAMPLE
2:
Following is a sample topology configuration for a non-redundant bump-in-the-wire (inline)
topology. All values are the system default values, so it is not necessary to type in the response.
Simply press enter at each line.
•
Connection mode — Inline
•
For a non-redundant topology, link bypass on-failure should be Bypass, so that traffic
continues to flow through the link.
•
After operation of the system resumes, and the
SCE 1000
reboots, the
SCE 1000
will resume
operation. (Admin status after abnormal reboot is Operational.)
Would you like to enter the Topology configuration menu? [no]:
y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
Enter On-failure behavior:
1- Bypass
2- Cutoff
Enter your choice [1]:
Enter admin status of the SCe after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
Data collection for the system configuration is completed.
