Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Cisco SCE 1000 2xGBE Installation and Configuration Guide
OL-7821-05
5-5
Parameter Definition
enterprise traps status
Set the status of the enterprise traps. (See Traps.)
system administrator
Name of the system administrator.
Topology Configuration
connection mode
Is the
SCE 1000
installed in inline topology or receive-only using an
optical splitter?
link bypass mode on
operational status
When the
SCE 1000
is operational, should it bypass traffic or not?
redundant
SCE 1000
platform?
Is there a redundant
SCE 1000
installed as a backup?
link bypass mode on non-
operational status
When the
SCE 1000
is not operational, should it bypass traffic or cut it
off?
operational status of the
SCE after abnormal boot
After a reboot due to a failure, should the
SCE 1000
remain in a Failure
status or move to operational status provided no other problem was
detected?
Following are some general instructions regarding the setup dialog:
•
All default values appear in square brackets [
default
].
If no value appears in the brackets [], or more than one option appears [
yes/no
], then this
parameter does not have a default value.
•
To accept the default value, press
Enter.
•
If you need more information about any parameter, type
?
and press
Enter
.
A help message will appear describing the expected format of the parameter and any other
requirements.
•
To jump to the
end of the setup dialog at any point, accepting all remaining default values,
press
^z.
•
In certain cases, there will be two or more logically related parameters within a menu. In these
situations, it is not permitted to jump to the end of the setup dialog until all related parameters
are configured. If you try to jump to the end of the setup dialog, the following message will
appear: “
Sorry, Skipping is not allowed at this stage
.”
•
Certain groups of related parameters, such as time, date, and SNTP settings, form sub-dialogs
or menus within the setup dialog. You may skip an entire menu, thereby accepting all default
values for the parameters within the menu.
Each group of related parameters is prefaced by a question, asking whether you want to enter
the menu. To skip the menu, answer no (“n”) to the question.
E
XAMPLE
:
Would you like to enter the SNMP configuration menu?
n
•
To abort the setup dialog at any point without making any configuration changes, press
^c.
All changes already entered will be lost, with the exception of time settings.
