D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
42
Cisco TelePresence MX200 G2 and MX300 G2
Administrator Guide
Network (LAN)
Connect the Touch 10 controller
(page 2 of 3)
Connect Touch 10 to the video system
via the network (LAN)
Connect Touch 10 and the video system to network wall
sockets or to a network switch as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up
procedure begins. Follow the instructions on screen.
When the
Select codec to pair with
dialog appears, note
the following:
• A list of video systems signalling that they are available
for paring will show up in the dialog. Tap the name of
the system you want to pair to followed by
Start Pairing
.
Note that the following must be fulfilled for a video
system to show up in the list:
• The video system and Touch 10 must be on the
same subnet.
• The video system must have been restarted within
the last 10 minutes. If the video system does not
appear in the list, try restarting it.
• If the video system does not appear in the list of
available systems, you can pair the devices manually.
Click
Select codec manually...
, enter the IP address or
host name of the video system, and tap
Start Pairing
.
• You have to enter the video system’s administrator
username and password for the paring process to
commence.
If Touch 10 needs software upgrade, new software will
be downloaded from the video system and installed on
the unit automatically as part of the set-up procedure.
Touch 10 restarts after the upgrade.
1
If the network infrastructure provides
Power over Ethernet (PoE), you do not
need a PoE injector; Touch 10 should
be connected directly to the wall socket
(Ethernet switch) with a PoE rated
Ethernet cable.
For safety, the PoE source must be in
the same building as Touch 10. The PoE
rated Ethernet cable can be up to 100 m
(330 ft).
Contact information
The video system’s
name or address is
displayed in the top
banner when Touch 10
is successfully paired to
the video system.
PoE
injector
AP
SWITCH
The Ethernet connector
is behind the lid at the
rear of Touch 10.
PoE rated Ethernet cable
Power
• 100-240 VAC
• 50/60 Hz
Network (LAN)
1
Standard Ethernet cable
Standard Ethernet cable
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices
Peripherals
