Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up IOS Access Points
5-18
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Using a Wireless LAN Services Module (WSM) as the WDS Device
If you are using a WSM to provide WDS, instead of using APs for WDS, follow
the procedures in the WSM documentation to configure it for WDS. Use the IP
address of the WLSE as the WNM IP address.
Configuring Infrastructure Access Points to Register with WDS Access Points
Infrastructure access points initiate participation in SWAN by registering and
LEAP authenticating with the WDS.
The only required configuration for infrastructure access points is the username
and password used to register with the WDS.
There are three ways to configure infrastructure access points to register with
WDS:
•
Using the access point web interface—See
Using the Web Interface to
Configure Infrastructure APs, page 5-18
.
•
Using the access point CLI interface—See
Using the Command Line
Interface to Configure Infrastructure APs, page 5-19
.
•
Using a WLSE configuration template—See
Using a WLSE Configuration
Job to Configure Infrastructure APs, page 5-19
.
Using the Web Interface to Configure Infrastructure APs
To use the web-based interface to configure infrastructure APs:
Step 1
Log in to the AP’s web interface.
Step 2
Select
Wireless Services > AP
.
Step 3
Select
Enabled
.
Step 4
Enter the username and password for authenticating the infrastructure AP to the
WDS.
Step 5
Click
Apply
.
